Ground rulesTurn the thermostat OFF and the power OFF before touching anything. Smell gas? Leave the house and call your gas utility from outside.
Burning smells or a breaker that trips again after one reset? Call a pro.
The 5-minute “before you call” checklist
- Thermostat: set to COOL or HEAT, at least 3° past room temperature, and the screen isn't blank.
- Filter: pull it out. Gray and matted means it's time.
- Breakers: look for a tripped breaker marked AC, furnace, air handler, or heat pump. Reset it once.
- Switches: the light-switch-style service switch near the furnace is ON, and the outdoor disconnect is in place.
- Furnace door: seated firmly, because a loose door keeps the system off.
- Water: no water standing in the pan under the indoor unit.
- Wait 5 minutes after any reset. Many systems have a built-in delay.
Air filters: the cheapest fix in HVAC
A clogged filter starves your system of air. It runs longer, costs more, and the indoor coil can even freeze solid.
- Check it every 30 days and replace it when it's dirty.
- The size is printed on the edge of the old filter.
- The airflow arrow points toward the furnace or air handler.
- Pets, remodeling, or dust mean you should check more often.
Tech tipSet a phone reminder for the 1st of every month and just look at it. It takes 30 seconds.
AC quit and there's water in the pan?
Your AC pulls gallons of water out of the air every day. When the drain line clogs, a float switch shuts the system off to protect your house.
- Thermostat OFF, and power OFF at the switch or breaker.
- Shop-vac the water out of the pan.
- Find where the drain pipe exits outside. Seal a wet/dry vac hose over it and run it for 1–2 minutes.
- If there's an access tee near the indoor unit, flush it with a cup of distilled white vinegar.
- Restore power. Once the water's gone, the float switch resets on its own.
Got a condensate pump? Check that its GFCI outlet isn't tripped. If it trips again right away, call a pro.
Cleaning your outdoor unit
Dirt, grass clippings, and cottonwood on the outdoor coil block airflow, and your system pays for it.
- Thermostat OFF, breaker OFF, and pull the outdoor disconnect.
- Clear debris and keep about 2 feet of open space around the unit.
- Rinse the coil gently with a garden hose on low pressure, from the outside in.
Never use a pressure washerIt flattens the thin aluminum fins and can ruin the coil. Keep water out of the electrical box.
Want the full step-by-step with photos, plus winter tips and capacitor warning signs? It's all in the guide.